hi I'm Sarah Haverstick safety advocate
with Evenflo so you found the perfect
car seat for your next decade of
adventure with your little thrill seeker
but now you need to know how to install
it well you've come to the right place
because today I'm going to show you how
to install the Evenflo
everything all-in-one car seat in
forward-facing mode with lower anchors
in tether before we begin please review
the instruction manual and all labels on
the car seat prior to use now squeeze
the recline handle on the front of the
seat and adjust the seat to the upright
position unhook the tether from the rear
of the car seat place the car seat on
your vehicle seat so that the child will
be facing the front of the vehicle
always make sure the bottom of the car
seat sits flat on the vehicle seat lay
the tether strap across your vehicle
seat back we will attach the tether to
your vehicle in a few steps unbuckle and
loosen the harness then remove the head
pillow and body pillow these are not
used in forward-facing over detach the
lower anchor connector from each side of
the car seat now we will move the lower
anchor connectors from the rear-facing
to the forward-facing belt path it helps
to remove some of the car seat pad to
access the lower anchor strap
[Music]
make sure the lower anchor connector is
facing upright and connect each side to
the corresponding anchor bar in your
vehicle to tighten the car seat grab the
excess tail and route it through the
forward-facing belt path with one hand
give firm pressure in the center of the
seat while you pull the tail to tighten
the excess strap with the other make
sure the lower anchor strap lies flat
and is not twisted and then replace the
seat pad to check for tightness grab the
seats at the belt path where you have it
installed it should not move more than
one inch from side to side or front to
back if the car seat moves more than one
inch when checking at the belt path try
to tighten the installation again if
that doesn't work you may need to change
seating positions or switch from a lower
anchor to a seat belt installation
connect the tether from the back of the
car seat to the corresponding anchor bar
in your vehicle then pull the tail to
remove excess slack for any additional
questions all evenflo car seats come
with parent link customer service perks
like real-time chat support and free
live video installation service for more
information please visit Evenflo comm