if your washer sounds like it became
unbalanced and is making some noise
sometimes you can easily fix it by
recalibrating the system and this works
on many models from whirlpool maytag and
kenmore washers from sears first you
need to reset the selector by turning it
counterclockwise couple of clicks and
now turn it right stop right stop right
stop left stop right stop
and now you should see all leds blinking
except for the last one on the right
this is a service mode and you can turn
the wheel in either direction until the
third led from the left lights up
not this one not that
that's what you need it's called
calibration mode press the start button
and watch the magic happen
the washer will go through a short few
minute cycle to calibrate all the
components and this calibration is
actually mandatory if you have just
replaced a main control board basket a
drive assembly suspension a motor or a
capacitor and if you don't recalibrate
it your washer will not work correctly
and a few minutes later the cycle has
completed just give it a sec for the lid
lock to unlock
and now you are ready to use your
recalibrated washer once again if this
calibration cycle worked for you as well
hit the like button and thanks for
watching
[Music]
[Applause]
funny
[Music]