hello welcome to Southern Cross in this
video we will go over the proper
procedure for changing out an electrical
meter remember to always wear
appropriate PPE your safety is of the
utmost importance to us
[Music]
knock on the customers door if there is
no answer continue with the change out
if the customer is there state your name
and company and what you will be doing
for them if there are any obstructions
remove them carefully before changing
the meter depending on the project you
may be required to perform a safety site
inspection take a picture of the site
condition before the meter exchange
verify the old meters number and type
then scan and take a picture of it
[Music]
enter the meter reading and before going
any further ensure you have all proper
safety equipment on and tested cut the
seal and inspect the meter rocks again
each project is different so the order
of these next few steps may vary if your
project requires it attach the bypass
jumpers stand off to the side and remove
the meter take a picture of the guts in
case of tampering or unsafe conditions
[Music]
perform a voltage test
[Music]
take a picture of the back of the meter
to confirm boots on the meter for unsafe
conditions like burning check the
replacement meter and verify the number
and type match the old meter install the
new meter and remove the jumpers if used
[Music]
clothes and seal the box
[Music]
[Music]
[Music]
take a picture of the new meter
displaying zeros in the new meter number
[Music]
scan the new meter
[Music]
clean your area and replace anything you
had to move if required take a picture
of the meter site showing the clean area
and properly mounted and sealed meter
leave a notice of the meter exchange for
the customer
[Music]
thank you for choosing Southern Cross
you