thank you for purchasing a coleman lazy
spa please keep in mind this video is to
accompany the printed user's manual and
is not a substitute pay careful
attention to the warnings and safety
instructions included in the manual and
be sure to visit your local pool
retailer for information on treating the
water in your spa the most important
part of setting up your lazy spa is to
select a suitable location for your spa
bear in mind that the total weight of
the spa when filled with water plus the
weight of the spa users adds up to a
considerable load therefore never set up
your spa on a surface that is anything
other than smooth flat level and capable
of uniformly supporting the weight for
the entire time the lazy spa is
installed not on the carpet or other
similar material also bear in mind that
the spa requires can be need water and
power sources for filling and operation
be sure also to clear the area of any
sharp objects or debris lay out the spa
in the selected location
open the inflation valve and press in
the center valve actuator next insert
the pressure gage and connect the
inflation hose next connect the other
end of the inflation hose to the pumps
air outlet this is marked with the
letter A connect the spa pump to a
suitable power outlet warning carefully
read your manual to determine the steps
required to power up the pump press the
Lazy massage system button to begin
inflating the spa
when the spa is fully inflated press the
Lazy massage system button again to
switch off the inflation function remove
the inflation hose from the spa and
screw on the inflation valve cap to seal
it next lay out the inflatable spa cover
with the underside facing upwards attach
the adapter nozzle and insert the
inflation hose in the spa covers past
inflate valve press the Lazy massage
system button to begin inflating the spa
cover
once the spa cover is fully inflated
press the Lazy massage system button
again to cease inflating remove the
inflation hose from the spa cover and
seal the fast inflate valve next detach
the inflation hose from the pump unit
move the pump unit close to the spa and
connect the air outlet and water inlet
and outlet ports to the spa ensure they
are tight
check that the drain port is press close
then remove the stoppers and attach the
filter set to the Lazy spas outlet valve
repeat this procedure removing the
remaining stopper and attaching the
second filter set and outlet valve next
fill the pool using your garden hose
taking care not to over or under fill
there is a level marker on the sidewall
of the pool to lock or unlock the pump
place a finger over the lock/unlock
button for three seconds
use this button to activate the heating
system when the light above the heat
button is red the heating system is
activated when the light is green the
water is at the set temperature and the
heating system is at rest this button
activates the water filtration system
this button toggles between Celsius and
Fahrenheit this button activates the
lazy massage system which is equipped
with a thirty minute
auto shutoff feature use the arrow keys
to input your desired temperature
use this button to set the heating
duration and when to activate the
heating system
after 72 hours of operation the pump
will hibernate and the LED display will
flash end and show the current water
temperature when the pump is hibernating
both the heating and water filter
functions are disabled to reactivate the
pump press the lock unlock button for 3
seconds and enter your desired
temperature
lastly place the cover on the lazy spa
attach it using the double lock safety
clips and tighten the straps
warning water attracts children always
securely attach the spa cover after each
use
to prevent children from accessing the
spa while unsupervised make sure the
double lock safety clips have been
properly fastened and tighten the straps
please note that the spa cover is not a
substitute for adult supervision
children must be supervised around the
spa at all times
you