hey guys here's a Roby corded circular
saw to speed up our DIY project we
bought this as it has 1500 watts power
and four years warranty compared to
other brands in the market for less than
$100 at Bunnings so first make sure you
have all the components and read the
instructions and safety guidelines
before starting to install the blade
you'll find the hex wrench on the side
under the handle you'll need to loosen
the hex bolt on the outer surface of the
blade you'll then need to find the
splenda lock tab which is near the front
handle you can then loosen the hex bolt
while depressing the lock once this is
done remove the bolt washer and outer
flange
now to install the blade you need to
make sure the saw teeth match the
direction of the sword guard reinstall
the components and tighten the hex bolt
again make sure the splinter lock tab is
depressed while tightening the bolt now
check that the law of God can be
retracted and check that the blade is
spinning freely as you turn it if you
notice the blade wobbling side to side
check that the hex bolt is installed
correctly to install the parallel guard
simply slide it through the slots to the
desired width and tighten the screw for
safety measures we left unboxing the
blade to the end just after we put on
our PPE we also used an outdoor back
here to reduce sawdust and had to make
do with the attachment we had but now
we're all ready to go