hello everyone uh so this video is about
connecting a thermal POS printer receipt
printer with your system uh using the
ethernet cable
this is suitable for long distance so
you can use this ethernet cable
here I have this ethernet cable and this
is printer
with the ethernet port
so I will be connecting one side of the
cable to this printer and the other side
to my laptop as my laptop do not have
ethernet port available so I will be
using this
uh USB to ethernet converter
okay so I have already connected one
side of the wire with the this printer
EOS printer and the other side to my
laptop after this step we need to take
the self test page from this printer to
know the IP address so for taking the
self test page first you need to turn
off the printer
and then
press both power and feed button at the
same time
it will bring the subject test page
here we have the IP address
192.168.123.100
okay so now let's start adding the
printer uh to our system for that first
of all go to control panel of your
computer
and go to network and internet
uh you need to open the ethernet option
go to properties
and open this
Internet Protocol version 4 TCP open the
properties
and use the following properties
so as you know in the printercept test
page the IP address was 192.
1
68
123 100 but here we will do
one zero one
and the subnet mask will be same
after that default gateway is 192
set one two three one
so this is the IP address
and subnet mask will be same and default
gateway will be same just need to change
the IP address the last figure
press ok
close
okay so after that we need to install
the driver
okay so driver is installed successfully
so now we need to configure the IP
address of the printer
and go to printers
so this is the printer which we
installed okay go to the printed
properties codes
add Port standard TCP IP port
so put the
IP address which was written on the self
test page
one to three point one hundred
press the next button
it will take some time
okay so the search was finished and this
pop-up appears keep it as it is and
press the next button finish
close
okay now you need to go to command
prompt
explain the IP address of printer
which was written on the selfless page
okay so we are getting reply from the
printer that's fine
after this we need to go to the printer
section
printer and scanners
printed properties and try to print the
test page
foreign