okay I thought I was going to show you
how to change the blade on a Black and
Decker miter saw because I didn't know
how to do it and I thought it might be
helpful here's the old blade came with
it here's the miter saw here Black &
Decker
under here right up in here you got a
little bolt I don't know if you can see
it but you got to turn that clockwise to
loosen it so what I did just grab a
little piece of wood and stuck it right
in here so that way the blade would turn
and hold itself against it and then I
put half-inch
up into here right anything like this
got it on here put that wood in it's
nice and tight I grabbed a hammer and
tapped it clockwise just to loosen now
you can't take the bolt all the way out
because the housing right here so I just
loosened it from there turn it this
direction you'll see three Phillips
screws you take this off and it'll slide
right out with the blade and all you can
remove the blade put the new one on
tighten it up slide it back in put the
three Phillips screws in and it'll be
done it's not that hard